Characteristics of polycarbonate greenhouse Harvest PC Leave a comment

The thickness of this substance is 4 mm.

If you want, you are able to boost the period of the construction to 6 yards or longer. To do this, it is enough to join a two-meter extension. When selecting a drawing, then focus on the distance between the arches. This figure must be 65 cm, which is the most appropriate length for the specified depth of the substance. The width of the doors according to the producer’s drawing is 90 cm.

Before building a polycarbonate greenhouse, then it is necessary to choose a place for its location. If that is done properly, you can provide yourself with a crop of fresh veggies for the whole calendar year.

The location for your future greenhouse is marked instantly in the preparation of the garden plot. In order to melt the snow at the positioning of their greenhouse as soon as possible, the very best point on the site will be a small elevation. Moreover, in such a location is not going to need to be worried about higher humidity as dirt and air within the construction.

Assemble a polycarbonate greenhouse in a raised site – means to look after the optimal temperature inside.

When it isn’t feasible to place a greenhouse in an elevated place, you will have to pour a layer of fine shattered rock around 20 cm and the identical layer of fertile land to create seedbeds.

Before assembling a greenhouse on your backyard plot, it’s also wise to think about where and how this structure is going to be installed. To begin with, you must choose a location for this. The greenhouse ought to be found in a well-lit area no less than a few meters away from homes, barns and other structures.

How to Put in a greenhouse according to the Surfaces of the world

Be sure to measure the dirt surface – it’s ideal to remove the top layer. This will also get rid of weed seeds. And for simplicity of work, eliminate the soil in an area that is about a meter wider on each side of the rectangle that you desire.

It’s also worth thinking about using a base. As producers say, now most greenhouses don’t need that, especially if they (greenhouses) are utilized only in the summer and spring period. However, seasoned anglers still suggest making at least a basic foundation from a bar. It is extremely simple – it’s sufficient to associate with each other using metal corners and screws four parts of wood using a cross-section of at least 10 * 10 cm. The dimensions of such a foundation should be equal to the foundation of their upcoming greenhouse.

Simple bar base

You might even earn a strip foundation of concrete. He’s more reliable than a bar foundation, but requires more fiscal and labour costs. Incidentally, the rainwater, that will be utilised in the winter, with no and do not do with it whatsoever.

Stages of the creation of a strip base: a schematic representation

Many producers advise to install greenhouse structures without even building a base. Even for this use, they equip the frame with special T-shaped legs, so the structure was securely fixed. But, as practice shows, it is still necessary to build a foundation: so and the foundation will be more firmly fixed and the components of the basis that are in contact with the ground, will be kept much longer in its original condition.

The main thing is to treat the material with specific agents to protect the timber from moisture. The material is normally installed on concrete blocks that are dug into the ground. For a six-meter structure, they need 10 bits: four on gidpostroy.ru each side and one in the middle of the ends.

Before you perform the greenhouse , you will need to pick the best place for it. It must be an even website, so the framework was located evenly, without distortions. It needs to be bright and not obscured by trees or buildings.

Leave a Reply